Below is a listing of devices supported by the Actsoft web applications.
|
Device |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
|
|
Ignition On/Off |
Ignition Off - One position sent per hour |
Active data plan |
|
Power Up - OBD detected (one after power up event) |
Ignition On - One position sent per minute |
Power supply per specifications |
|
|
Heartbeat |
Cellular and GPS antenna |
||
|
Hard acceleration/ deceleration |
Configuration loaded via the PULS website (administered by Actsoft) |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
On Board Alert Programmable Engine Generator (PEG) |
Ignition On/Off |
Ignition Off - One position sent per hour |
Active data plan |
|
Connectors - three (3) available I/O connections |
Power Up |
Ignition On - One position sent per minute |
Power supply per specifications |
|
|
Messaging - records up to 10,000 locations and alerts |
Four (4) digital inputs |
Cellular and GPS antenna |
||
| Over-the-Air (OTA) Configuration and Firmware Updates |
Hard acceleration/ deceleration |
Configuration loaded via the PULS website (administered by Actsoft) |
||
| Internal backup and cellular antennas | ||||
| Low power sleep mode |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
On Board Alert Programmable Engine Generator (PEG) |
Ignition On/Off |
Ignition Off - One position sent per hour |
Active data plan |
|
Connectors - three (3) available I/O connections |
Hard Acceleration/ Deceleration |
Ignition On - One position sent per minute |
Power supply per specifications |
|
|
Accelerometer |
Power Up |
Cellular and GPS antenna |
||
| Over-the-Air (OTA) Configuration and Firmware Updates |
OBD detection (once after power up event) |
Configuration loaded via the PULS website (administered by Actsoft) |
||
|
Check Engine (activates if check engine light is on, or if the light has been reset while fault codes still exist) |
||||
|
Seatbelt (activates when seatbelt is fastened - not supported on all vehicles) |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
Expanded Interface - selectable/ switchable voltage power for peripheral device installation |
Ignition On/Off |
Ignition Off - One position sent per hour |
Active data plan |
|
Accelerometer |
Hard Acceleration/ Deceleration |
Ignition On - One position sent per minute |
Power supply per specifications |
|
|
Messaging - records up to 20,000 locations and alerts |
Hard Acceleration/ Deceleration |
Cellular and GPS antenna |
||
| Power Sleep Modes |
Power Up - OBD detected (one after power up event) |
Configuration loaded via the PULS website (administered by Actsoft) |
||
| Over-the-Air (OTA) Configuration and Firmware Updates |
Check Engine Light (activated if check engine light is active) |
|||
| Barcode Swipe Support |
Seatbelt (activated when a seatbelt is fastened - not supported on all vehicles) |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
On Board Alert Programmable Engine Generator (PEG) |
Ignition On/Off |
Ignition Off - One position sent per hour |
Active data plan |
|
Connectors - three (3) available I/O connections |
Power Up - OBD detected (one after power up event) |
Ignition On - One position sent per minute |
Power supply per specifications |
|
|
Messaging - records up to 10,000 locations and alerts |
Input/Sensor Events (4 events on 2 inputs) |
GPS positions sent immediately for events such as ignition on/off and digital input |
Cellular and GPS antenna |
|
| Over-the-Air (OTA) Configuration and Firmware Updates |
Configuration loaded via the PULS website (administered by Actsoft) |
|||
| Internal Backup and Cellular Antenna | ||||
| Low power sleep mode of less than 1mA |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
Up to 7 year battery life |
Power Up - OBD detected (one after power up event) |
Device with a magnet taped in place is in sleep mode, and will not track
|
Active GSM, SIM or CDMA data plan |
|
Internal 57Ah battery |
Internal Battery Low (when at 20% capacity) |
When Fast Track is enabled, device enters Fast Track state at next scheduled position |
Actsoft configuration loaded via the PULS website (administered by Actsoft) |
|
|
Weatherproof enclosure |
Fast track |
Disabling fast track resumes default tracking of 1, 2 or 4 times daily |
||
|
Built-in cellular and GPS antenna |
||||
| Over-the-Air (OTA) configuration and firmware updates |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
Internal Backup Battery |
Ignition On/Off |
Ignition Off - One position sent per hour |
Active data plan |
|
OBDII-capable with adapter |
Hard acceleration/ deceleration |
Ignition On - One position sent per minute |
Power supply per specifications |
|
| Over-the-Air (OTA) configuration and firmware updates |
Power Up |
Motion detected while ignition = off triggers an event and a check for significant movement over a 5-minute period (Speed >= 8mph for 30 consecutive seconds) |
Cellular and GPS antenna |
|
|
Internal Battery low |
If significant movement is detected, device will begin tracking every 5 minutes until no movement is detected for 10 consecutive minutes. Then, it will resume once per hour tracking |
Configuration loaded via the PULS website (administered by Actsoft) |
||
|
Two (2) digital inputs |
||||
|
Motion detected |
||||
|
External Power Applied/ Removed |
If no significant movement is detected after 5 minutes, device resumes once per hour tracking |
|
Because the Enfora MT-2500 uses GPS data instead of the vehicle OBD port, some data may not be as accurate and/or stay in synchronization. Data affected are:
· Speed data
· Speed-Exceeded Events
· Odometer/Mileage (odometer must be re-synced over time)
· RPM, Acceleration/Deceleration and Direction change events are not supported
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
Three-axis digital accelerometer |
Ignition On/Off |
Ignition off - One(1) position sent per hour |
Active GSM SIM |
|
Connectors - six (6) available I/O connections |
Power Up - OBD detected (one after power up event) |
Ignition on - One(1) position sent per minute |
Power supply per specifications |
|
|
Programmable rules engine and control and automation capabilities |
Input/Sensor Events (4 events on 2 inputs) |
GPS positions sent immediately for events such as ignition on/off and digital input |
Actsoft configuration script loaded via USB cable |
|
|
Internal antenna |
||||
| Optional internal rechargeable battery | ||||
| Polygon geo-fencing |
|
Device |
Key Features |
Supported Events |
Tracking Rules |
Minimum Device Requirements |
 |
Three-axis digital accelerometer |
Ignition On/Off |
Ignition off - One(1) position sent per hour |
Active GSM SIM |
|
Connectors - six (6) available I/O connections |
Power Up - OBD detected (one after power up event) |
Ignition on - One(1) position sent per minute |
Power supply per specifications |
|
| Voice and data features |
Low Battery |
GPS positions sent immediately for ignition on/off and hard acceleration/deceleration |
Actsoft configuration script loaded via USB cable |
|
|
Full GPS/GSM/GPS connectivity |
RPM | |||
| Heartbeat |
|
Device |
Key Features |
Minimum Device Requirements |
 |
Optional Internal rechargeable battery |
Active data plan/SIM |
|
Over-the-Air (OTA) Configuration/ Firmware Updates |
Power supply per specifications |
|
|
Messaging - records up to 4,000 locations and alerts |
Network-specific cellular and GPS antenna |
|
|
Actsoft configuration profile |
|
Device |
Key Features |
Supported Events |
Minimum Device Requirements |
 |
Integrated GPS engine and GPS antenna |
Ignition On/Off |
Active GSM/SIM |
|
Over-the-Air (OTA) configuration/firmware updates |
Power Up |
Power supply (hard wired to vehicle battery or constant 12V supply) |
|
|
Device removal notification |
Low battery |
||
|
Heartbeat - once daily |
|||
| Speed Exceeded |
|
Device |
Key Features |
Supported Events |
Minimum Device Requirements |
 |
Integrated GPS engine and GPS antenna |
Ignition On/Off |
Active GSM/SIM |
|
Over-the-Air (OTA) configuration/firmware updates |
Power Up |
Power supply (hard wired to vehicle battery or constant 12V supply) |
|
|
Device removal notification |
Low battery |
||
|
Heartbeat - once daily |
|||
| Speed Exceeded |
Related Topics
